NANO-STAR
Nanotech Waterproofing & Protection
NANO-STAR'S TOP SELLER - NSC NANO WATERPROOFER
N S C | Nano Waterproofer for Concrete
WORLD CLASS NANOTECH WATERPROOFING
NSC is our most popular waterproofing product to date. It is a water-based nanotized spray-on water tightening treatment for porous substrates. Coated surfaces powerfully resist water ingress and stay dry even in humid conditions. NSC is a high-penetration impervious-inducing solution.
HIGH PERFORMANCE NANO PARTICLES
DIFFICULT TO BEAT NSC PERFORMANCE
At our labs, we formulate the best suspension to create a stable product suitable even for heavy duty industrial use. Stringent lab practices allow NSC to function and perform at a much more stable and long lasting rate than other similar nano products in the market.
STELLAR RECORD
10 year life span (lab tested)
TENDER SPECIFIED
"Long Term Surface Protection & Water Proofing to Substrates using Approved Water-Based Nanotized Spray-on High-Penetration Impervious-Inducing Water Tightening Treatment such as Nano-Star NSC Nano Waterproofer or equivalent."
NSC contains lab-engineered Nano-Star nano-particles with Class 2 penetration of more than 10mm. Our particles are dynamic and smart - strong bonding and powerful water proofing.
GREEN LABEL CERTIFIED
HDB MATERIAL LIST APPROVED
GREEN LABEL CERTIFIED
HDB MATERIAL LIST APPROVED
INTRODUCTION VIDEO AND PRODUCT POSTER
PRODUCT SPECIFICATIONS
Nano-Star NSC is a water-based liquid formulation. It provides effective waterproofing and surface protection for a wide range of building surface types.
With viscosity close to that of water, NSC nanoparticles (NPs) are able to penetrate deeply into capillaries that no other elastomer or polymer can. This nanotechnology based composition guarantees effectiveness, prolonged lifetime of coated surfaces and ZERO visible change to the original look / shine of the substrate.
While traditional waterproofing coats simply create a "film" over the substrate which is subject to weather, wear and tear, NSC NPs embed themselves deep into the pores without clogging up the substrate. This method of treatment makes it virtually impossible to be damaged or corroded. It cannot be removed via mechanical or chemical means.
Yet, due to the incredibly small particle
size, NSC treated surfaces remain
breathable. This is very important as
moisture will be able to escape from
inside relieving negative pressure to
prevent swelling, cracking and warping.
NSC treated surfaces are also
more UV resistant. This reduces the
"yellowing" effect of surfaces under
sunlight.
Previously branded Nano-Star NS Seal C / Nano Seal C.
PHYSICAL PROPERTIES
Milky white, water emulsion with slight odour
pH: 7.1
Boiling & Flash Point: > 100 deg.
Auto Ignition Point: > 100 deg.
Density: 1.01 g.cm-3
Viscocity: 20mPa.s
NS Seal C is not considered an oxidant.
SAFETY & STORAGE
NSC contains no hazardous ingredients and is water-based.
VOC Content: 0.7 g/L (well below limit)
Not hazardous at all.
APPLICATION
Surface should be dry and clean. Apply NSC with a brush or spray. No dilution. On very absorptive surfaces reapply within 3 hours. Curing takes 8-24 hours.
MIXING WITH CEMENT
Replace 1/3 water with NSC during mixing of batch.
CONSUMPTION
10-15 sqm/L